Buy Tobacco Leaf Online | Whole Leaf Tobacco

Pine Morton’s First Grow - 2025

Pine Morton

Active Member
Joined
Apr 23, 2025
Messages
33
Points
33
Location
Georgia
Whenever my transplants look like that, I give them a big drink of a soluble (therefore instantly available) of triple-20 fertilizer at full strength, along with half a teaspoon of Epsom salt per gallon. Usually perks them up and gets them green, again.
I’ll give that a shot. Just need to get my hands on the fertilizer.

Found this little guy on one of my KY5 plants too. Justice was carried out swiftly.

IMG_4404.jpeg
IMG_4405.jpeg
 

Pine Morton

Active Member
Joined
Apr 23, 2025
Messages
33
Points
33
Location
Georgia
Following johnny108’s advice, I fertilized my plants on 7/6. Each pot received 1 gallon of water with 1 tablespoon of 20-20-20 fertilizer and half a teaspoon of epsom salt. Three days later on 7/9, and they’re definitely looking much better.

Virginia Gold:
IMG_4434.jpeg
IMG_4436.jpeg

KY5:
(Wow!)
IMG_4435.jpeg
IMG_4437.jpeg

I went ahead and repotted the two best plants that were still in the smaller pots into my last two big pots. They got the same solution of fertilizer and epsom salt:

IMG_4433.jpeg
IMG_4432.jpeg
 

Pine Morton

Active Member
Joined
Apr 23, 2025
Messages
33
Points
33
Location
Georgia
It’s been a while, but the plants are doing better than ever. A few small worms here and there, but luckily the damage has been negligible.

IMG_0176.jpeg

The KY5’s are starting to get their buds too:

IMG_0175.jpeg

I think I might be closing in on a harvest, and my curing chamber isn’t even built yet…
 

Pine Morton

Active Member
Joined
Apr 23, 2025
Messages
33
Points
33
Location
Georgia
I’ve noticed that the KY5 has gotten some grey spots on the leaves… hopefully this isn’t an issue. I know there are some mushrooms growing out of the potting mix on one of them.

IMG_0280.jpeg
IMG_0279.jpeg

The KY5 is also ready to bloom. I’ve heard that I need a special kind of bag, but I thought I might just use a ziploc to bag one of them.


IMG_0281.jpeg
 

deluxestogie

Administrator
Staff member
Joined
May 25, 2011
Messages
25,603
Points
113
Location
near Blacksburg, VA

Pine Morton

Active Member
Joined
Apr 23, 2025
Messages
33
Points
33
Location
Georgia
IMG_0306.jpeg

Got the paint bag. It was tricker to get it on than I expected… a few buds fell off. We’ll see if I get any usable seeds.

I went ahead and topped the other KY5 too. The Virginia Golds don’t have any buds yet.

The small plants I left in their tiny pots have what I think might be sooty mold. The small plants have been attracting whiteflies like crazy, but I didn’t think anything of it… are these leaves trash now?

IMG_0316.jpeg

I don’t want it to spread to my main plants. I will toss them if necessary.

The grayish spots on the bigger plants have spread to one of my Virginia Golds too. Starting to get worried that I’ll lose my leaves here at the end.

IMG_0317.jpeg

It has been very rainy in my area these past few weeks. I’m hoping this is just damage from the leaves staying wet.
 

Pine Morton

Active Member
Joined
Apr 23, 2025
Messages
33
Points
33
Location
Georgia
IMG_0443.jpeg
IMG_0448.jpeg

Started the harvest on my KY5. The first pic was the first hand I put together a couple of days ago now. The second pic is the progress on the first hand plus the new hand that I just picked today.

I still haven’t harvested any of the Virginia Gold yet.

I’m hoping I didn’t harvest too soon. The leaves on the KY5 were developing even larger brown patches though, so I figured I’d better try to salvage what I could before it got too far gone. No idea what this is or if it will impact the tobacco, but it came on very quickly over the course of a week or so.

IMG_0444.jpeg

IMG_0445.jpeg

IMG_0446.jpeg

This was the worst one. I’ve picked most of these lower leaves now, but this plant hadn’t even flowered yet.
 

wruk53

Well-Known Member
Joined
Jul 14, 2020
Messages
620
Points
93
Location
Naples. Fl
No offence intended, but I wouldn't tie freshly cut leaves into hands. It's very likely to mold and rot where it's all bunched tightly together. Normally, tobacco is tied into hands after it's been color cured, dried and then brought back into case.
 

Pine Morton

Active Member
Joined
Apr 23, 2025
Messages
33
Points
33
Location
Georgia
No offence intended, but I wouldn't tie freshly cut leaves into hands. It's very likely to mold and rot where it's all bunched tightly together. Normally, tobacco is tied into hands after it's been color cured, dried and then brought back into case.
None taken, that makes sense. I don’t want to lose any leaf… I went ahead and strung them up individually. I also picked the rest of the KY5 to prevent any more brown patches from forming. I’m thinking I should have done this a week ago.

I did leave the top two leaves on the plant that I let flower. They’re small, but TBH I care more about salvaging my leaf than I do getting seeds, so if the plant dies before the seeds come in then oh well.

As for my Virginia Gold, I still haven’t picked any leaves. They’re only just now starting to form buds, and the brown patches aren’t a problem on these… yet.

IMG_0449.jpeg
(The KY5 harvest)
 

Pine Morton

Active Member
Joined
Apr 23, 2025
Messages
33
Points
33
Location
Georgia
Another update… this time it’s sad news.

I was attempting to sun cure my Virginia Gold in a plastic tote, but lost track of the days and lost most of the harvest to mold.

IMG_0622.jpeg

Most of the leaves look like this. Not sure if it’s worth it/advisable to cut out the mold to salvage the rest.

IMG_0620.jpeg

Lost about 28 leaves. The majority of the Virginia Gold.

IMG_0621.jpeg

This is what remains that isn’t molded. A few color cured leaves and some still yellowing.

At least my burley did well enough. I have almost 50 leaves of the KY 5 color cured and dried. I’ve put off placing them in a box to age because I’ve been very busy with the birth of my first daughter… probably why I lost track of the Virginia Gold.
 

green_bean

Member
Joined
Jul 11, 2025
Messages
12
Points
13
Location
North Georgia
Agree w/ you about the mushrooms. Actually, when I see fungi growing in our woods, yard, on the wood pile, etc., I gather them up and bust them up, and put them in my compost pile. Have read where some folks go so far as to mix them in a blender with water and then pour all that on the compost. I haven't found the need to do the blender thing. However, if I see a known poisonous mushroom, like an amanita for example, I leave that kind where it sits.
 

johnny108

Well-Known Member
Joined
Feb 23, 2023
Messages
1,076
Points
113
Location
Germany
Agree w/ you about the mushrooms. Actually, when I see fungi growing in our woods, yard, on the wood pile, etc., I gather them up and bust them up, and put them in my compost pile. Have read where some folks go so far as to mix them in a blender with water and then pour all that on the compost. I haven't found the need to do the blender thing. However, if I see a known poisonous mushroom, like an amanita for example, I leave that kind where it sits.
Paul Stamets outlined a method he called “spore mass inoculation”.
It consists of taking a 5 gallon bucket of water, adding 1-2 grams of salt (to inhibit bacteria), and 50ml of molasses to it, and adding a mature mushroom to it, leaving it to soak for 4 hours. Then allow the spores to germinate in the “broth” for 24-48 hours at a temperature of 50-80F (10-27C), while you prep a wood chip pile, etc. to be inoculated with the spore slurry.
This will result in a pretty healthy mycelium growth, but you will have to tailor the mushroom bed to the specific variety in order to guarantee mushrooms to harvest.
I’ve been looking into it as a way of dealing with the massive amount of branches and sticks I have to deal with in my garden, as hauling them away is a logistical nightmare.

Source: Growing Gourmet and Medicinal Mushrooms, by Paul Stamets.
Page 24 of the book/pg40 of this pdf file:
 

StoneCarver

Active Member
Joined
Aug 26, 2025
Messages
36
Points
18
Location
Winston-Salem,NC
I’ve been looking into it as a way of dealing with the massive amount of branches and sticks I have to deal with in my garden, as hauling them away is a logistical nightmare.
You'd be amazed at how quickly stuff can break down without any sort of inoculation. If you could rent/borrow a chipper shredder to reduce stuff into smaller particle sizes, it makes the process all that much faster. You can also till the chipper shredded stuff into the soil in the fall.

I don't mean to jack Pine Morton's thread, but I will admit I have a copy of Paul's book. Thanks for reminding me about the spore slurry. Boletes grow in the mulch beds at work and I've been trying to transplant them to my mulch beds at home for several years now with no luck. But I haven't tried the spore slurry method. I had forgotten about that. Boletes are good eating.
 

GreenDragon

Well-Known Member
Joined
Jan 18, 2018
Messages
2,127
Points
113
Location
Charlotte, NC
@Pine Morton Congratulations on your first born! You are doing great for a first year grow. It's a steep learning curve and the first two years growing is all about figuring out what works for you and your location. Each year it gets easier and the harvests get bigger and better quality. Enjoy the time with the family - time flies by so fast the next thing you know they're moving out, going to college, and getting married!
 
Top