Sticking with bach 5 over warp 10 is probably a good call. No point in getting the chickens clucked up, that would just be fowl.
Oldfella's kiln build
- Thread starter Oldfella
- Start date
- Status
Oldfella
Well-Known Member
Just what Astro-chickens need to work to.
Oldfella
Well-Known Member
Finally, turbine is a runner. On the bench it seems to be performing perfectly. Getting a little bit warm but not too bad and it may settle under load.
Got some baccy to be pressed tomorrow so that's going let it have a good run.
Got some baccy to be pressed tomorrow so that's going let it have a good run.
Oldfella
Well-Known Member
O.K. So today turned to Custard as far as baccy pressing was concerned took me longer at the hospital getting my dressings
Changed. Nevermind it's all good, and tomorrow is another day. I managed to complete my astro kiln driver, pic below.
We have lift off yaaaah. Sorry if the pics are a bit jumbled it's the excitement. The setup allows infinite control of the air flow using a damper to cover a wide range of drying and cureing conditions. Nealy built a Kiln. Baccy pressing tomorrow, no excuses. Going to try; Bursa, Golden Havest, and Yellow Twist Bud. I'll start with equal parts and go from there. Ar well over to grow blog page now.
Changed. Nevermind it's all good, and tomorrow is another day. I managed to complete my astro kiln driver, pic below.
We have lift off yaaaah. Sorry if the pics are a bit jumbled it's the excitement. The setup allows infinite control of the air flow using a damper to cover a wide range of drying and cureing conditions. Nealy built a Kiln. Baccy pressing tomorrow, no excuses. Going to try; Bursa, Golden Havest, and Yellow Twist Bud. I'll start with equal parts and go from there. Ar well over to grow blog page now.
Oldfella
Well-Known Member
Hi flying Astro-Chickens.
Looks like the Astro training has paid off.
Bit of pressing taking place.
Some very nice looking leaves here, it's going to fun on the taste test.
Looks like the Astro training has paid off.
Bit of pressing taking place.
Some very nice looking leaves here, it's going to fun on the taste test.
Oldfella
Well-Known Member
Hi all, back again I just had to have a period of morning, I had to shoot Astro chickens, they came back from astro training with bad habits, no eggs!
looks like I'll have to learn to drive the kiln, chickens were 5 years old and they laid every day of it, so they deserve the rest.The way my health is I don't think that I'll get
anymore
Back to the build. I've been able to source some Aluminum sheets. Has anyone used it in a kiln? If it's screwed and sealed onto the interior of the kiln it should be good. I could use it for the air circulation and heating thingy.
Here it is, I'm using it as my little Tractor house at the moment but Tractor don't need that much room.
looks like I'll have to learn to drive the kiln, chickens were 5 years old and they laid every day of it, so they deserve the rest.The way my health is I don't think that I'll getanymore
Back to the build. I've been able to source some Aluminum sheets. Has anyone used it in a kiln? If it's screwed and sealed onto the interior of the kiln it should be good. I could use it for the air circulation and heating thingy.
Here it is, I'm using it as my little Tractor house at the moment but Tractor don't need that much room.- Status
